I grabbed this little wobbly table right out of my dad’s hands as he reared back to toss it into the dumpster, now you know something is in sad shape if it’s not worth the space it takes up in a barn full of junk! Anyway that was a few years back and since then it has lived by my bed, on the porch and finally in an out building. But with Lisa and me looking for items for the booth we plan to set up in January, I pulled it out and took a fresh look at its possibilities.
The black paint concealed the colors but not the ragged texture of the multiple layers of paint globbed on beneath. The legs were loose, very loose; one had actually broken through the table top which had also shortened one side considerably. It was in sad shape, but there was just something sweet about its form. So after my hubby stabilized the top and legs, the best that could be done, I started to work painting. I decided to use a dry brush technique that embraced its primitive nature; and I chose a beautiful blue that puts me in mind of the sea.
Lisa had been looking for a project to try a technique she had seen somewhere that involves stitching on wood. With that in mind we developed a plan to transform the little ugly table into a beautiful home accessory.
Using a new piece of plywood cut to fit the top of the table, we painted on layers of paint that we then distressed and crackled. We stitched on a border using a beautiful multi colored yarn and applied a single starfish using gold leaf.
This is what we ended up with…
a lovely little table to treasure.
How to stitch on wood:
We drilled holes about 1 1/2 inches from the edge of the wood using a 3/16 inch bit. The needle was a six-inch piece of thin, flexible wire folded in half and, using pliers, pinched at the fold to make it small enough to fit through the drilled holes. Sliding an end of the yarn onto the makeshift needle and starting on the underneath side, I pulled the yarn up through a hole and down through the next hole, creating a running stitch; tying off the ends on the underneath side. To compensate for the bulk of the yarn on the bottom of the stitched piece, we glued very thin strips of plywood along the underneath edge and a couple of strips along the center. Finally, we applied glue along the strips we had added and attached the completed piece to the table top; clamping in place until set.